Alerts
Loading...
| Signal Name | Description | Condition | Impact |
|---|---|---|---|
|
High possibility of moisture in air system.
|
|
Decreased system pressure, no regeneration availability
|
|
|
Software internal error.
|
|
No electronic governing (The system is continuously in load till the safety valve opens at 13.5 Bar), No regeneration, No pressure indication, Red Stop Lamp, Diagnostic unavailable
|
|
|
Software dataset error.
|
|
No electronic governing (The system is continuously in load till the safety valve opens), No regeneration, No pressure indication, Red Stop lamp, Diagnostic unavailable
|
|
|
Service mode has been activated, compressor control is restricted.
|
|
-
|
|
|
Pressure sensor in C1 or C2 is out of range.
|
|
Decreased brake activity
|
|
|
Power supply error.
|
|
No electronic governing or regeneration available, Yellow Warning lamp active
|
|
|
Regeneration valve short circuit or external excitation.
|
|
-
|
|
|
Open/short circuit of regeneration valve.
|
|
No regeneration
|
|
|
Valve high side shorted to battery.
|
|
-
|
|
|
Valve high side open circuit.
|
|
No valve actuation
|
|
|
Governing valve short circuit or external excitation.
|
|
No electronic governing
|
|
|
Internal hardware failure occurred.
|
|
No electronic governing or regeneration, no pressure information, possible damage of pneumatic components
|
|
|
Electric compressor speed over CAN is missing.
|
|
-
|
|
|
Dataset not configured.
|
|
-
|
|
|
Compressor usage above normal.
|
|
Possible leak in system and insufficient air dryer regeneration
|
|
|
Circuit 1 reached max pressure level.
|
|
No electronic governing or regeneration available, diagnostic available
|
|
|
Low pressure warning for circuit 1.
|
|
May not be able to unpark and reduced service brake capability
|
|
|
Circuit 1 has defect.
|
|
Decreased brake capability
|
|
|
An imbalance in the State of Charge (SOC) of the High Voltage (HV) battery has exceeded the warning threshold.
|
The estimated imbalance between average SOC and minimum SOC is greater than the alert threshold
|
Indication that SOC imbalance is increasing. Maximum range and charge will be reduced if imbalance continues to increase.
|
|
|
The battery management system (BMS) detects a possible state of charge (SOC) imbalance.
|
The BMS detects that the difference between the most-charged brick and the least-charge brick in the high voltage (HV) pack is greater than the acceptable threshold.
|
Maximum SOC is reduced to 50%.
|