Alerts
Loading...
| Signal Name | Description | Condition | Impact | Important |
|---|---|---|---|---|
|
BCFPM_w040_MirrorMotor
|
setcondition
|
These are the repercussions of the alert being set
|
No
|
|
|
BCFPM_w039_MirrorMovement
|
Mirror failed to change movement states.
|
These are the repercussions of the alert being set
|
No
|
|
|
BCFPM_w032_WindowCommError
|
Lin frame error.
|
These are the repercussions of the alert being set
|
No
|
|
|
BCFPM_w031_WindowRegulator
|
Error from LIN.
|
The windows could be malfunctioning.
|
No
|
|
|
BCFPM_w057_ReflectorLamp
|
The desired state of the reflector lamp could not be set, the current state is not the expected one or the light did time out
|
These are the repercussions of the alert being set
|
No
|
|
|
BCFPM_w056_MirrorHeatError
|
Mirror heat enable failed
|
Mirror may not be heated when it should be
|
No
|
|
|
BCFPM_w030_LockedDoorOpened
|
Door state open and locked.
|
These are the repercussions of the alert being set
|
No
|
|
|
The door controller's left or right side configuration is invalid or unspecified.
|
Door controller side configuration is not set, invalid, or cannot be determined by reading the dedicated harness pins. Alert payload data should provide more information on the specific condition(s) involved.
|
Door controller may not communicate and will not operate as expected. Run the correct 'Side Learn' action to configure it.
|
No
|
|
|
Not Available
|
NVRAM detected as corrupted.
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
Flash CRC is corrupted.
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
Any of the signals in message RCM are set.
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
No
|
|
|
The log data contains failure count and up to five init failure codes.
|
A task init function returns with an error.
|
If an init routine fails, software may not opperate correctly.
|
No
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
No
|
|
|
Not Available
|
Reasons to keep the controller awake have been the same for greater than one hour
|
The bus could not sleep causing significant range loss for the battery pack
|
No
|
|
|
Not Available
|
A signal is received 10% out of timing 3 times in a row.
|
These are the repercussions of the alert being set
|
No
|
|
|
After a record upgrade is successful, resetting the ECU should clear the alert.
|
Record not found, CRC mismatch, Version mismatch, Version upgrade.
|
Indicate the state of non-volatile data in the ECU.
|
No
|