Alerts
Loading...
| Signal Name | Description | Condition | Impact |
|---|---|---|---|
|
Not Available
|
Current detected > x A for 10ms.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
LIN error flag set.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
LIN error flag set.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
LIN error flag set.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Task could not be scheduled because it was already running or pending.
|
Failure to run tasks on schedule.
|
|
|
Not Available
|
Current detected > x A for 10ms.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Current detected > x A for 10ms.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Current detected > x A for 10ms.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
The brake fluid switch is disconnected or reports a fault status
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Low level switch becomes active for 60 seconds.
|
These are the repercussions of the alert being set
|
|
|
Latch feedback switch is stuck in a shorted state. Switch could be malfunctioning, or claw could be mechanically stuck closed.
|
Latch driven open but switch status remains closed.
|
Frunk may be stuck closed, or could actually be open when car thinks it is closed.
|
|
|
Not Available
|
Switch activated 30 times in 60 seconds.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Switch is active for more than 30s continuously.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Vehicle speed > 0 kph and a frunk open request was received.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Frunk ajar and vehicle speed > 0 kph.
|
These are the repercussions of the alert being set
|
|
|
Check that actuator is connected, harnessed correctly, and not damaged.
|
Unusually high current during an actuation
|
Frunk latch may malfunction
|
|
|
This alert is unreliable and has been disabled in the embedded firmware.
|
Unusually low current during an actuation
|
Frunk latch may malfunction
|
|
|
Check that actuator is connected, harnessed correctly, and not damaged.
|
Unusually high current during an actuation
|
Frunk latch may malfunction
|
|
|
Not Available
|
NVRAM detected as uninitialized.
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
Unsuccessful communication with NVRAM.
|
These are the repercussions of the alert being set
|