Alerts
Loading...
| Signal Name | Description | Condition | Impact |
|---|---|---|---|
|
Not Available
|
Vehicle did not unlock after crash.
|
These are the repercussions of the alert being set
|
|
|
Provides information about the unexpected stop.
|
PLG stops unexpectedly
|
-
|
|
|
Not Available
|
No falcon door pinch strips pressed or disconnected
|
Pressed: door will not move unless under manual control, Disconnected: TBD
|
|
|
Not Available
|
A falcon door (B Pillar Button) button is stuck down
|
Falcon door B pillar button that is stuck, it's signal is ignored
|
|
|
Not Available
|
Falcon door 12V pump rail in error
|
Falcon door will not move or performance will be impacted
|
|
|
Not Available
|
Falcon 5V rail in error
|
Falcon door position sensors and pinch strips will not function
|
|
|
Check spoiler mechanism. mechanical failure may be present.
|
Spoiler motor stall current is reached when the spoiler in not near either endstop
|
Spoiler may have mechanical issue or be blocked
|
|
|
Production vehicle should not have Debug Jumper in place. Remove jumper from ECU.
|
ECU Debug Jumper is set.
|
ECU Debug Jumper will disable SBC watchdog, preventing external watchdog reset protection.
|
|
|
Log contains CPU load for each task.
|
CPU load exceeds 80%.
|
High CPU load can indicate ineffecient code.
|
|
|
Log contains stack usage for each task.
|
Stack usage exceeds 80% for any task.
|
Stack overflow can occur if there is not enough stack space.
|
|
|
Check spoiler mechanism. mechanical failure may be present.
|
Spoiler motor stalls during auto calibration state
|
Spoiler may have mechanical issue or be blocked
|
|
|
Not Available
|
The Freescale HSD has been returned bad data on the MISO line from the microprocessor more than 10 times in a row.
|
HSD outputs could toggle endlessly causing lights to strobe forever.
|
|
|
reseting the controller should fix the issue
|
Driver side config stored in NVRAM does not match the config sent by GTW
|
controller may have behaviors that correspond with the wrong side of the car
|
|
|
Communication failure to the oil pump
|
The oil pump has experienced a communication or connection fault, detected by the rear body controller.
|
Oil pump will operate at max flow rate if LIN failure and no flow if unpowered.
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|
|
|
Not Available
|
setcondition
|
These are the repercussions of the alert being set
|