Alerts

The DIx ECU has detected an error with ADD.

Gear train and drive line thuds and noise typically dampened by ADD may be more noticeable.

The DIx power stage has applied a safe state.

Some DIx features may be disabled, or may not function expected. The Drive Unit may not function as expected.

The PM detects a condition that requires it to intervene and disable powertrain.

Vehicle drive torque is immediately disabled.

LV supply voltage to DI is disconnected or drops below lower voltage threshold.

The DI ECU triggers limp mode (see separate limpMode alerts) and cannot produce torque or power.

HV bus voltage exceeds set upper voltage threshold

Unable to produce torque/power from drive unit

The FPGA detects a 5V supply regulator PGOOD is not working as expected.

Readings from 5V sensors may become erratic.

The Switch Off Path Test (SOPT) for Drive Unit has failed. The DIx and PM torque measurements are different. The pathway between DIx and PM may have a condition affecting functionality.

PM may not be able to shut down torque produced by Drive Unit.

The DIx ECU has detected a peak in Phase A.

DIx may be inoperable.

The DIx ECU has detected a peak in Phase B.

DIx may be inoperable.

The DIx ECU has detected a peak in Phase C.

DIx may be inoperable.

The DIx ECU has detected the current sensor RMS current has exceeded the expected RMS threshold on Phase A.

DIx may not function as expected, including vehicle power being limited.

The DIx ECU has detected the current sensor RMS current has exceeded the expected RMS threshold on Phase B.

DIx may not function as expected, including vehicle power being limited.

The DIx ECU has detected the current sensor RMS current has exceeded the expected RMS threshold on Phase C.

DIx may not function as expected, including vehicle power being limited.

The DIx ECU has detected the current sensor offset has exceeded the threshold on Phase A. Phase A hardware may need investigation.

This alert is intended for logging purposes. Phase A hardware may need investigation.

The DIx ECU has detected the current sensor offset has exceeded the threshold on Phase B. Phase B hardware may need investigation.

This alert is intended for logging purposes. Phase B hardware may need investigation.

The DIx Phase A current sensor is irrational. An irrational current may indicate a high rate of change or current measurement out of sensing bounds. There may be a condition affecting current input and output.

If the alert asserts at the beginning of a drive cycle, DIx may not enable. If the alert asserts during a drive cycle, DIx may be disabled. DIx may not function as expected.

The DIx Phase B current sensor is irrational. An irrational current may indicate a high rate of change or current measurement out of sensing bounds. There may be a condition affecting current input and output.

If the alert asserts at the beginning of a drive cycle, DIx may not enable. If the alert asserts during a drive cycle, DIx may be disabled. DIx may not function as expected.

Imbalanced phase currents detected. See payload signals for reason of trigger

Drive unit enters unit limp mode (see DI_a126_limpMode)

HV bus voltage (refer to busVoltage) exceeds upper voltage theshold (refer to busHighLimit)

Unable to produce torque/power from drive unit

HV bus voltage (refer to busVoltage) drops below lower voltage threshold (refer to busHighLimit)

Unable to produce torque/power from drive unit